GigaBeam_Gi-Core_WiFiber_G1.25

User can be logged in by serial, telnet and ssh to a CLI or to shell. Depends on setting in /etc/passwd.

User with leve 1 logged to CLI can access and change all settings according to manual

g1.25_installation_and_operations_manual_031706.pdf

Basic setting overview: 1 Login to the radio using CLI as an admin user (level 1).

Change ip address 2 GVFR#c t 3 GVFR(config)#conf 4 GVFR(config-Conf)#ethernet 5 GVFR(config-Conf-Ethernet)#set ipaddress 192.168.1.230 (default) 6 GVFR(config-Conf-Ethernet)#set addressmask 255.255.255.0 7 GVFR(config-Conf-Ethernet)#set gateway 192.168.1.1

Set admin password 2 GVFR#c t 3 GVFR(config)#conf 4 GVFR(config-Conf)#async 5 GVFR(config-Conf-async)#Admin 6 GVFR(config-Conf-async-admin)#set password The screen displays prompt for a new password success {new password}

To save the configuration to flash, continue with the following commands: 2 GVFR#c t 3 GVFR(config)#conf 4 GVFR(config-Conf)#misc 5 GVFR(config-Conf-Misc)#set save on

Check signal TBD Check data link on sfp TBD